3 LabVIEW 2010 DSC Module Features and Changes. This document also describes the new features available with version 2010 and compatibility and upgrade issues you might encounter when you use version System Requirements. NI myRIOs feature a third way for upgrading the firmware.1 RELEASE AND UPGRADE NOTES LabVIEW Datalogging and Supervisory Control Module Version 2010 Contents This document describes the system requirements and the process of installing the LabVIEW 2010 Datalogging and Supervisory Control (DSC) Module and the DSC Module Run-Time System. See the below table for a list of devices and their associated firmware folder names. It is recommended that you upgrade the firmware of your target after you upgraded your driver version. For example, firmware updates for a cRIO will be provided to your computer when installing the NI CompactRIO Driver. However, in most cases, firmware versions other than the latest one will work just fine. Currently firmware updates are distributed to your PC with the specific device driver. In general, NI recommends updating to the latest firmware version available. You can find more information in this example program. Click Begin Update.įirmware can be updated using the Upgrade Firmware VI.
The above window will close and another will appear.Find a supplementary table in the section Additional Information below showing which folder belongs to which device. Select the firmware version you want to update and click Open. From there, navigate to the Device Family of your device and the folder corresponding to the target. The location for all firmware files is \National Instruments\Shared\Firmware\. A window will pop up where you need to browse to the firmware file.By default the username is admin and the password is left blank. Navigate to the IP address of the LinuxRT Target.
Open Internet Explorer (Microsoft Silverlight is required).The above window will close and the below window will pop up.
From there, navigate to the Device Family such as, Ethernet cRIO folder, of your device and the folder corresponding to the target if the location is not already loaded correctly. Find a supplementary table in the section Additional Information below showing which folder belongs to which device. By default, the window should load to the correct location as shown below.On it's System Settings tab, click the Update Firmware button. Under Remote Systems, select the device you want to update.Then you can perform the change following the methods below. To downgrade firmware, you will need to download older versions of the driver to be able to do so. There are three different methods to upgrade or downgrade a device's software:
0 kommentar(er)
